miniature fm voice transmitter

Parts List:
R1 = 4.7K             Q1 = 2N3904
R2 = 330 ohm          L1 = see text
C1 = 0.001uF (1nF)    Electret mike, antenna, 3V battery (button cell)
C2 = 10-40pF
C3 = 4.7pF

Construction:
This is another easy-to-build miniature transmitter that uses a minimum of parts. Construction is straight forward and non-critical. Although this design uses a 3-volt power source (such as a lithium coin or button cell), a 9-volt battery can be used, instead, by increasing the value of R1 to 15K and R2 to 1K. C4 is an optional RF bypass capacitor that may help improve performance and increase the range a bit. Experiment to find best results.
L1 was made by stripping 22 gauge hookup wire of it's insulation, then wrapping it in the grooves of the screw threads of a 1/4 diameter bolt, and then back-screwing the bolt out of the resulting coil. 8 turns were made around the bolt. By wrapping the turns in the threads, a uniform seperation was made between the coil windings.

If you decide to substitute transistors with something similar you already have, it maybe necessary adjust the collector voltage of Q1 by changing the value of R2 or R3 (because you change transistors, it changes this bias on the base of Q1). It should be about 1/2 the supply voltage (about 4 or 5v).

Notes:
The default for the capacitors type is ceramic, preferably the npo 1% type or equivalent. But basically nothing critical here. Use any capacitor you have laying arround, but no electrolytic or tantalum caps. Don't go out and rush to the store. Most parts can be salvaged from somewhere. Only if you intend to use this circuit outside the home you may want to select more temperature stable capacitors.
I'm not sure about the range. With the 3V supply it is probably around 100 feet or so. The 9V supply will beef up the range considerably, again not tested, but probably in the 300 feet range or so.

To find the signal on your receiver, make sure there is a signal coming into the microphone, otherwise the circuit won't work. I use an old mechanical alarm clock (you know, with those two large bells on it). I put this clock by the microphone which picks up the loud tick-tock. I'm sure you get the idea... Or you can just lightly tap the microphone while searching for the location of the signal on your receiver.

Our other product:

Professional lightning protection system for Tower	Professional FM Radio Station Equipment Package	FMUSER FU-1000C 1000W FM Transmitter With USB Audio Input Interface
FMUSER 200W FM Radio Broadcasting Package	Hotel IPTV Solution	FMUSER FSN-1000T V5.0 1KW FM Radio Broadcast Transmitter