Design scheme for realizing reservoir 24h wireless monitoring system using LA-5830F bridge

On-site overview Guangxi Baise a large reservoir, and it has implemented a wireless monitoring system program for 24 hours. The geographical environment is more complicated, and the air is moist in long-term, and the people around the reservoir move safely. The reservoir has a curved angle, and there is a small mountain in the middle. To realize the surveillance of the environment and personnel of the reservoir. Monitoring is achieved by the four weeks of the reservoir. Therefore, the 24h monitoring is selected by wireless microwave. On-site needs The reservoir is approximately a bending angle, and the various orientations around the reservoir must be monitored, and the full-scale no dead angle. 24h monitoring. Reservoir line is less than 2 km long. The reservoir is installed around 4 million HD cameras, the highest point in the reservoir dam position, all signal transmission collects the dam position, and is transmitted from the dam to the monitoring center opposite the monitoring road. There is a point in the monitoring center, which can be achieved with the wiring party. The video signal of No. 4 No. 3 can be directly transmitted to the location of the reservoir. Due to the hill occlusion, it is in the hill position to take a transition method, transfer By the 3rd point, it is brought to the reservoir dam. Solution design and equipment selection The camera's live camera is 2 million network HD, which is compared to the surrounding environment of the reservoir, and some of the uncertain interference factors, I use our company's LA-5830F5.8G300M high-performance wireless bridge. Transmission distance is within 3 km of public. And the antenna acceptance angle is large (60 degrees), each point is used independently, and the video signal is transmitted with a LA-5830F bridge. The same equipment transfers are used in the local turn. The topology is as follows: Solution analysis Our company produces the LA-5830F high-performance wireless bridge, built-in integrated antenna, can point-to-point and point-to-multi-point transmission, so the customer is on site, can be concentrated, using points to receive signals in multipoints, save costs. In order to ensure the real-time and smooth data transmission, the transmitted end and reception must be empty. Customer on-site requirement 1. The customer site is 24h real-time monitoring, in order to ensure the normal monitoring site environment of wireless monitoring equipment, all wireless monitoring devices and monitoring equipment are powered by stable voltage. 2. The normal supply voltage of the wireless bridge is the supply voltage of DC 12-24V, and each wireless bridge we will configure a PoE and a power adapter for customers. 3. Connect the bridge of the camera and wireless bridge, there is also a PoE network cable, which can use CAT5E (control over 70M) or CAT6 (control over 100M) cable. 4. Wireless monitoring belongs to the establishment of a local area network, and the IP address of the wireless bridge cannot conflict with the IP address of the camera. Editor in charge: GT, read full text