E + H vortex flow meter installation instructions

1: E + H vortex flow metering requires precaution analysis: 1. Reasonably select the installation place and environment. Avoid strong power equipment, high frequency equipment, strong power switch equipment; avoid the impact of high temperature heat sources and radiation sources, avoid strong vibration places and strong corrosive environments, while considering convenient installation and maintenance. 2, the piping downstream of the E + H vortex flowmeter mounting point should be concentric with the sensor, and the coaxial deviation should not be less than the standard value. 3. Pipeline takes a dismissal measures. Sensor Try to avoid installation on the vibration tube, especially lateral vibration. If there is no need to install, the damping measures must be taken, and the pipe fastening device is provided at the upper and downstream 2D ​​of the sensor, and the anti-vibration pad is added. 4. Installation of flow sensors is commonly installed in the horizontal pipe. When the gas flow is measured, if a small amount of liquid is contained in the gas, the sensor should be mounted at a higher level of the pipeline. When the liquid flow is measured, if a small amount of gas is contained in the liquid, the sensor should be mounted at a lower point of the pipeline. 5, the sensor installation in the vertical pipeline. When measuring the gas flow, the sensor can be mounted on a vertical conduit, and the flow is not limited. If a small amount of liquid is contained in the gas, the gas flow should be upward. When the liquid flow is measured, the flow direction should be upward: this does not additionally attach additional additional addition to the probe. 6, the sensor on the side of the horizontal pipe. Regardless of the fluid, the sensor can be placed on the horizontal pipe, in particular measuring superheated steam, saturated steam and cryogenic liquid. If the condition allows for easy adoption of the side, the temperature of the fluid is smaller. 7, the sensor flips in the horizontal pipe. This mounting method is not recommended in general. This mounting method is not suitable for measuring the general gas, superheated steam. It can be used to measure saturation vapor, suitable for measuring high temperature liquid or often cleaning the pipeline. 8, the sensor is installed on the insulation layer pipe. When high temperature steam is measured, the insulation layer cannot exceed one-third of the height of the stent. 9, the choice of measurement point and temperature measurement point. According to the measurement needs, when the pressure and temperature should be measured near the sensor, the test point should be at 3-5d from the downstream of the sensor, and the temperature measurement point should be at 6-8d downstream of the sensor. Editor in charge: WV

Our other product:

Professional lightning protection system for Tower	Professional FM Radio Station Equipment Package	FMUSER FU-1000C 1000W FM Transmitter With USB Audio Input Interface
FMUSER 200W FM Radio Broadcasting Package	Hotel IPTV Solution	FMUSER FSN-1000T V5.0 1KW FM Radio Broadcast Transmitter