TABER wear system operation test
Taber wear-resistant operation test is suitable for leather, cloth, coatings, paper, floor tiles, fittings, glass, natural rubber, etc. to wear-resistant tests, the method is used to cut the test piece with standard cutters, with a specified model of grinding wheel, and load certain Wear wear, take out the test piece after the specified number of revolutions, observe the status of the test piece or the weight difference between the test piece before the test piece test, the weight of the test, the calculation formula of the wear index: wear loss weight / test Rotary × 1000 Choose a grinding wheel number: H-18, H-22, CS-10, CS-17, CS-32, CS-33
Taber Wear Structure Steps
Preparation before test
Before the test, the instrument is required to access the power supply, and the exhaust port is connected to the vacuum cleaner.
Accessories and other instruments: standard grinding wheel pair, double-sided adhesive (hard), fine sandpaper (check). According to different standards, it is necessary to prepare 0.1mg precision balance, fabric strong machine, appearance evaluation light box, etc. to evaluate the test results.
Sample: Cutting is about 110mm, and the holes are 8mm in the middle. If you need to compare the changes before and after the sample, you need to weigh the sample original weight (such as the sample is a fabric, etc., it is necessary to stick the standard double-sided adhesive to the outer stickers, weigh the total weight) If you need to compare the strong changes before and after the sample, you need to test its original strength before the test; other properties such as haze need to be tested before testing to determine the original parameters. The sample needs to be pre-adjusted for at least 8 h.
Acceleration: After power-on, start the instrument in the arms raised state, and adjust the speed control knob to the required speed according to the digital display.
experiment procedure
Mack sample
Place the tailor-like samples on the test bench.
Keep the sample flat, tighten the pressing nut and gasket, and fasten the sample fixation ring with hex wrench.
Matching grinding wheel and weight
The pre-ground standard wear wheel is mounted on the inside of the balance arm and tighten the tension.
The weight weight or balance weight according to the desired pressure pack.
The wear wheel of the corresponding specifications is installed according to the wear wheel specification of different material tests in the corresponding standard.
start up
Turn on the power switch. Set the number of preset rings on the counter. Press the start button, the motor drives the turntable to start rotation.
Note: 1. When the grinding wheel grinds the surface of the sticker or the surface of the grinding wheel, replacement is required. 2. Before testing a sample, you need to clean the grinding wheel with a brush.
Sample results evaluation
After reaching the number of times, the instrument automatically stops or determines that the test end is to stop the test, turn off the vacuum cleaner. Take out the sample for evaluation.
Evaluation method (for reference only, see all standard regulations):
Quality loss method
The percentage of weight loss was calculated using accurate to 0.1 mg of balance to 0.1 mg.
Strong loss
The use of a strong instrument to perform a strong test on the test before and after the test, and calculate the percentage of strong losses.
Appearance of the number of schedules
After reaching the number of predetermined turns, the appearance is evaluated (usually polished, light transmissive changes, etc.
FQJ, read full text
Our other product:
