Introduction to the HDMI and URP Reception Display Module

H.264 decodes HDMI, av is simultaneously displayed, and can also decode display via USB port Android mobile phone 1-way two-way wireless transmission Ethernet port, 2-way two-way wireless transmission RS232 serial port, 1 channel single wireless transparent TTL serial port 1 TTL 1 channel audio input, can directly pick the microphone Low delay 1080p @ 60fps H.264 decoding; HDMI, the AV interface simultaneously outputs the decoded audio and video, and supports the USB port Android mobile phone decoding display to provide Android App; Support TF card or U disk storage wireless received video, recording files can take time information; Support microphone input audio; At the same time, it supports the 1-way Ethernet and 2 RS232 serial port wireless two-way transparency, and the 1-way TTL serial port is one-way wireless transmission; Support audio input and output to implement two-way audio wireless transmission function; Double antenna emission and reception, MIMO work mode; Support wireless band: 2304 ~ 2390MHz, center operating frequency point can be configured; Radio bandwidth: 4MHz or 8MHz, the vacation rate is up to 25Mbps; Maximum transmit power: 1W; Receive sensitivity: -102dBm (4MHz bandwidth); Wireless link encryption and decryption: 128 bit AES; Support wide voltage input: 7 ~ 24V; Module Size: 109.4 * 86 * 25mm, does not include the size of the interface side, and weight 113g. Silica two-way wireless transmission link HD map transmission module implementation function: 1) Multiple receiving modules can interface with a transmit module for bidirectional wireless transmission; 2) Ethernet port corresponding to the transmitting module to achieve a two-way OFDM wireless transmission; 3) RS232_A of the transmitting module to achieve a two-way OFDM wireless transmission of the RS232_A serial port of the receiving module; 4) The RS232_b of the transmitting module corresponds to the RS232_B serial port of the receiving module to achieve two-way OFDM wireless transmission; 5) The TTL data serial port corresponding to the receiving module implements the TTL data serial port of the receiving module to achieve one-way OFDM wireless transmission; 6) The MIC audio input of the receiving end corresponds to the speaker output of the transmitter; 7) The transmitted HDMI or SDI or AV audio is output to the HDMI and AV interface of the receiving end together; 8) Connect the transmitting end and the received parameter serial port with the receiving end via the Hyroda Passage Module (see the Jarda Command], such as setting the encoded rate of the transmitting end, the time of the receiving end, and the like; 9) The wireless transmission and receiving parameters of the transmit terminal and the receiving end can be set by the network connection. 10) Measured data: The air-to-ground wireless transmission distance exceeds 10 kilometers, and the wireless transmission distance is more than 2 kilometers. Read more