Development Tools: Jlink V7.0
Development environment: IAR5.3
Step 1: Download Library
Download the STM32 V3.0 firmware library from the Stm32 V3.0 firmware library from the ST official website.
Step 2: Copy library file
After extracting the downloaded hardwareware library, copy the [libraries] directory in the directory into your project directory, then [Template] directory under the [Template] directory in the [Template] directory, STM32F10X_IT.C STM32F10X_IT.H four files to your directory, then copy [Project] - [Template] - [EWARMV5] to your own check. So after these completion, your project is almost shown in the following picture:
Step 3: Load files
Start the IAR5.3 development environment, choose to establish a new project in the current workspace, select the Tool Select, select ARM; project template selection, select the empty item directly, click OK button, prompt the project file storage location, You can save it directly to the previously created project catalog. Then add each file group as shown below and add the corresponding file into it.
Step 4: Configure IAR 5.3
Right-click on the project file (such as MyProject - Debug in the figure above), select the [Options] button in the right-click menu, the project configuration tab will appear. Select [General Options], select [Device] in the [Target] page, then click the Device Select button on the right side of [Device] to select your STM32 chip. After the selection is completed, it will be as follows:
Select [C / C ++ Compiler], then select [PreProcessor] page in the text box of [Additional Include Directories], enter the header file address of the index required for your project. After the configuration is complete, it will be as follows:
Select [Linker], then select [Config] page, select the [Override Default] check box, click the file selection button on the right side of the text box, select the file you want to connect to the configuration in your project root (for example Ready to run the program in Flash, select STM32F10X_FLASH.ICF). After the configuration is complete, it will be as follows:
Select [Debugger], then select the [SETUP] page, select [J-Link / J-TRACE] in the [DRIVER] drop-down selection box, and after the configuration is complete, the following figure shows:
After completing the post-operation, click the Make Command button, prompt to save Workspace file, enter the name you want to save (for example, name myProject on the above item), click Save, and compile the system. After compiling, Warning [PE223]: Function "Assert_Param" Declared Implicitly warning, because there is no reason for the Stm32f10x_conf.h file, it is possible to declaration in the header file of Main.c.
Through the four steps, you can use IAR to build a project you want, but in the IAR configuration introduction, I just made a basic configuration introduction, readers want to know more of more IAR's environmental instructions, You can directly refer to the Help file of IAR to learn in-depth. If there is anything in the text, I also hope that all friends don't ask. thank you very much!!
STM32 single chip microcomputer Chinese official website
Semiconductor / STM, reading
Our other product:
